What is a cycling thermostat?

The cycling thermostat is responsible for cycling the dryer’s heat source on and off to keep a target temperature, set at the timer or with a temperature selection switch.

A highlimit thermostat is a switch that is actuated by temperature change. This high limit thermostat acts as safety mechanism to keep the dryer from overheating. Once the dryer temperature reaches 221 degrees Fahrenheit, this piece will shut down power to the heating element until it drops by 80 degrees Fahrenheit.

Beside above, how many ohms should a dryer thermostat have? Your meter should be set at the lowest setting. The thermostat should read 0 ohms. If your meter does not move when you test the part, it will have to be replaced.

In respect to this, what does a dryer thermostat look like?

Dryer thermostats are usually oval shaped and about an inch and a half in length. Also, there should be two wires leading to each thermostat. Label these wires before you remove them so that you are able to correctly reconnect them later. At room temperature, testing the thermostat should produce a reading of zero.

How many thermostats does a dryer have?

Modern dryers usually have more than one thermostat: a cycling thermostat that turns the heating element off and on to keep the temperature even; and either a high-limit or thermal thermostat that cuts power to the heating element if the dryer overheats.

Is there a thermostat in a dryer?

There are two different thermostats in your dryer, the operating thermostat(s) and the high limit ( safety ) thermostat(s). The only difference in these thermostats is their opening and closing temperatures. Some common area’s to find the thermostats.

Why do tumble dryers have two thermostats?

The heat thermostat on your tumble dryer is there to monitor and regulate the temperature being produced by the appliance when it is in use. If the thermostat isn’t able to do this, it will trip as a safety precaution.

Is dryer worth repairing?

It can be worth spending $150 – $200 to repair a midrange or high-end dryer that’s less than three years old, for example. While a new basic model costs only $300 or so, a nicer model would cost much more. Repairing it can extend its life so you can get your money’s worth.

How do I know if the thermal fuse is blown?

Touch the left multimeter lead to the left side of the thermal fuse; touch the right multimeter lead to the right side of the fuse. Keep an eye on the multimeter needle; a needle that fails to move indicates a blown thermal fuse. If this is the case, don’t fret: thermal fuse replacement is a simple task.

Should a dryer thermostat have continuity?

At room temperature, the thermostat should give off a continuity reading of zero, so touch one probe to one terminal and the other probe to the other terminal and check the tester’s display. It should read zero. If it reads infinity, then the thermostat is bad.

How do I reset my thermal fuse?

How to Reset a Thermal Fuse Unplug the clothes dryer’s power cord from the wall outlet. Swing the front panel out towards you so that you can look into the compartment. Aim a flashlight at the flat-can-like component to locate the blown thermal fuse.

Can you bypass the thermostat on a dryer?

Remember to unplug the dryer first. The idea would be to bypass the thermostat, hi-limit or thermal cutoff one at a time and see if the dryer will heat. Start with the control thermostat on the blower housing next to the thermal fuse. If it doesn’t heat then the thermal cut-off and hi-limit can be checked the same way.

How much does a thermostat cost for a dryer?

Cost and Repair Considerations As of 2012, hiring a repairman to install a new thermostat cost around $177, while purchasing the thermostats to make the repairs yourself cost less than $60. A new appliance can cost you anywhere from $300 to $1,400.